Brow CodeLustre Advanced Lamination

1: Apply Brow Code’s Lustre Brow Adhesive evenly throughout the brow in a thin layer. Use a disposable spoolie brush to comb and fix the hairs in place in an upward direction. Ensure you are setting the brow in the exact direction you wish to laminate the hairs in. Leave to dry.
2: Apply Brow Code Brow Perming Solution to one brow at a time using a disposable spoolie brush to comb and fix the hairs in place in an upward direction. Take care to keep solution to the hair area only. Cover brows with Brow Wrap to ensure the hairs are fixed in an upright position. Leave for 5-8 minutes but no longer than 9 minutes.
3: Remove the cling wrap and remove Brow Code Perming Solution with a dry cotton tip. If any excess product remains, use a damp cotton tip to remove from the tips of the hairs. Apply Brow Fixing Solution to both brows. Cover again using your Brow Wrap to fix the hairs into place. Leave on for 5-8 minutes but no longer than 9 minutes.
4: Remove the Brow Wrap and remove Step 2 with a dry cotton tip. If any excess product remains, use a damp cotton tip to remove from the tips of the hairs.
5: Apply Brow Keratin Nourish to both brows. Use a generous amount to ensure this is applied to the hair and the skin. Remove after 2 hours with a dry cotton tip or pad.
6: To nourish your skin and brows, we recommended to follow up with the Brow Gold Oil daily.

BROW LAMINATION AFTERCARE:

What should and should not be done 24 hours post-treatment for the longevity of results:
Keep brows dry for 24 hours.
Use Brow Code Gold Brow Growth Oil daily.
Do not apply make-up or undertake further eye treatments for at least 24 hours after your treatment.
Avoid swimming/sauna/working out for 24-48 hours. Any excess moisture after this time can cause a slight curl/frizz to the brow hair.
Do not allow prolonged exposure to direct sunlight or heat.
Do not apply Retin-A, AHA or exfoliate around the brow area for 72 hours either side of the treatment.
No self-tanning products should be used on the face for one week prior and 48 hours after treatment.
NOTE: If any stinging or swelling occurs, apply a cold compress to soothe and seek medical advice. 
CAUTION
Avoid contact with skin and eyes.
If in eyes wash out immediately with water. For advice, contact a Poisons Information (Australia 13 11 26; New Zealand 0800 764 766) or a doctor at once.
If swallowed do not induce vomiting.
If in eyes, hold eyelids apart and flush the eye continuously with running water. Continue flushing until advised to stop by the poisons information centre or a doctor or at least for 15 minutes.

Perming: 
Aqua, ethanolamine, thioglycolic acid, cetearyl alcohol, sodium coceth-30 sulfate, ammonia, dimethylbenzyl carbinol
Fixing:
Aqua, sodium stannate, hydrogen peroxide, sodium phosphate, dibasic dodecahydrate, cetearyl alcohol, dimethylbenzyl, carbinol
Keratin noursih: 
Portulaca oleracea extract, sunflower seed oil, chysanthellum indicum extract, sophora flavescens root extract, phtassium hydrogen phosphate, tirethanolamine, hydroxybencyl, sodium hyaluronate, aqua
Lustre lamination adhesive
Water, propylene glycol, ethanol ,1,3-butanediol, ethylhexylglycerin, acrylates/laurylacrylate/stearylacrylate/ethylamine oxide methacrylate copolymer, polyvinyl alcohol,vinylalcohol polymer, pyp